Actiontec M1000 Routed Bridging

These configuration instructions will guide you through configuring your Actiontec modem with your static IP address on the modem.

  1. Follow the instructions provided with your Actiontec modem to connect your Actiontec modem to your computer and DSL line.

    Your computer should be configured to obtain an IP address automatically from the Actiontec modem. If you are using a Macintosh, select Configure Using: DHCP Server in your Network Preferences.

  2. Open a web browser and enter 192.168.0.1 in the Address Bar. On the screen that appears, click on the Quick Setup tab.
  3. Click on the link labeled, Click here for advanced settings only if required by your ISP.
  4. Now you should see the following.
  5. In the Wan IP Address section, under the first step, choose RFC 1483 via Static IP
  6. In the Select the IP type section, enter the IP address, subnet mask, and gateway address supplied by our DSL department.
  7. Scroll down the screen until you see Select the DNS type
  8. Move the radio button to Static DNS
  9. For Primary DNS, enter: 216.99.193.19
  10. For Secondary DNS, enter: 216.99.193.2
  11. Then, click the Apply button to save the changes
  12. You're done. It may take a minute or two for the Actiontec to save the changes, but once it does, you'll be able to access the Internet through your Actiontec M-1000 modem.

What are People Saying about SpiritOne?

"The reason I came to SpiritOne is that it was a small company that was geared to the individual that techies (unix and windows savvy) would love and my wife (the non-techie) could use the service."